Why does the planetary deceleration machine appear broken axis imagination?

      Why does the planetary deceleration machine appear to be off axis? The first possible problem with broken shafts is the quality of the planetary reducer. Of course, this is what we can think of in ordinary times. The most important reason is the reason caused during the normal use. For example, how should we pay attention to the acceleration and deceleration of the planetary reducer, and what are the good ways? 

      First，some applications must strictly abide by this criterion. This is not only to protect the reducer, but also to prevent the output shaft of the planetary reducer from being twisted. This is mainly because if there is a problem with the installation of the equipment, the output shaft of the reducer and its load are stuck. At this time, the overload capacity of the drive motor will continue to increase its output, which may cause the output bearings of the reducer to suffer. When the force exceeds 2 times of its rated output torque, the output shaft of the reducer is twisted.

      second，In the process of acceleration and deceleration, if the instantaneous torque multiplied by the output shaft of the planetary reducer exceeds 2 times its rated output torque, and this acceleration and deceleration are too frequent, then the reducer will eventually be broken. axis. Considering that this situation is rare, it will not be described further here.

      third，The wrong selection results in insufficient output of the reducer. Some users mistakenly think that as long as the rated output torque of the selected planetary reducer meets the working requirements, in fact, it is not true. First, the rated output torque of the motor is multiplied by the reduction ratio. The value obtained in principle should be less than The rated output torque of the similar reducer provided by the product catalog, the second is to also consider the overload capacity of its drive motor and the maximum working torque required in practice. Theoretically, the user needs the maximum working torque. Must be less than twice the rated output torque of the reducer.

      Among them, when using a planetary reducer, we must pay attention to its code of conduct, and at the same time have a fatal output reason for the wrong selection. The shaft breakage problem of the reducer output is too small, the planetary reducer shaft breakage is a common problem. Except that the shaft of the reducer is broken due to the poor concentricity of the output end of the reducer. The above three points are possible causes and problems.